SEAT IBIZA CUPRA 1.8L TURBO 134kW/180HP ME7.5

ECU BOSCH ME7.5 · 182 CV (134 kW) · 1800 cc · Benzina sovralimentato

ECU 数据库SEAT › SEAT IBIZA CUPRA 1.8L TURBO 134kW/180HP ME7.5

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 1 固件版本

车辆数据

品牌SEAT
型号IBIZA CUPRA
发动机1.8L TURBO 134kW/180HP ME7.5
原厂功率182 CV / 134 kW
排量1800 cc
燃料Benzina sovralimentato
车辆类型Auto

ECU

制造商BOSCH
型号ME7.5
存储 / EPROM29F800 PSOP44 8Mbit - Flash 512K x 16

可用的调校选项:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Boost pressure limiter 4
  • Boost pressure limiter 5
  • Boost pressure limit control
  • Height correction for boost pressure
  • Desired engine load calculation
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • Lambda enrichment for components protection
  • RPM Limiter
  • Boost pressure linearization
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum boost pressure load
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

固件标识 (1)

硬件号软件号 (chip)版本升级软件ECU
02612085211037371739 1.42.01606A906032RP 0010 BOSCH ME7.5

ECU 说明

Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. On this epron can be set a KEY. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This Setting File can be used for serial system NewGenius. Attention! If you use the serial system: before start the program, disconnect the feeding on the fans radiator.