PORSCHE MACAN (95B) 2.9L V6 24V GTS 279kW/375HP MG1CS002

ECU BOSCH MG1CS002 · 380 CV (28 kW) · 2900 cc · Benzina sovralimentato

ECU 数据库PORSCHE › PORSCHE MACAN (95B) 2.9L V6 24V GTS 279kW/375HP MG1CS002

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 3 固件版本

车辆数据

品牌PORSCHE
型号MACAN (95B)
发动机2.9L V6 24V GTS 279kW/375HP MG1CS002
原厂功率380 CV / 28 kW
排量2900 cc
燃料Benzina sovralimentato
车辆类型Auto

ECU

制造商BOSCH
型号MG1CS002
存储 / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte

可用的调校选项:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Optimal spark timing/MBT 2
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Torque limiter 2
  • Torque limiter 4
  • Torque limiter 5
  • Torque limiter 6
  • Torque limiter 7
  • Torque limiter 8
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Engine speed limit temperature based
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Max torque profile for diagnostic
  • Optimal engine moment
  • Power limit torque table
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Throttle angle management
  • Turbocharger volumetric efficiency

固件标识 (3)

硬件号软件号 (chip)版本升级软件ECU
1.02.00495B907551AM 0001 BOSCH MG1CS002
1.02.00495B907551AM 0002 BOSCH MG1CS002
1.02.00495B907551AD 0001 BOSCH MG1CS002

ECU 说明

Microprocessor BGA FREESCALE SPC57xxx This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata