PORSCHE CAYMAN (987) 2.9L DFI Mk2 155kW/208HP ME7.8.2

ECU BOSCH ME7.8.2 min · 211 CV (155 kW) · 2900 cc · Benzina aspirato

ECU 数据库PORSCHE › PORSCHE CAYMAN (987) 2.9L DFI Mk2 155kW/208HP ME7.8.2

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 1 固件版本

车辆数据

品牌PORSCHE
型号CAYMAN (987)
发动机2.9L DFI Mk2 155kW/208HP ME7.8.2
原厂功率211 CV / 155 kW
排量2900 cc
燃料Benzina aspirato
车辆类型Auto

ECU

制造商BOSCH
型号ME7.8.2 min
存储 / EPROM29F800 PSOP44 8Mbit - Flash 512K x 16

可用的调校选项:

  • Base timing
  • Minimum advance allowed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Factor to correct fuel delivery system 2
  • HFM/HLM air flow high limit
  • HFM/HLM air flow low limit
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Lambda efficiency
  • RPM Limiter
  • RPM Limiter 2
  • Lambda driver wish
  • Knock detection factor
  • MAF sensor calibration
  • Maximum ignition delay allowed for knock limiter intervention
  • Throttle air mass flow calculation
  • Minimum engine air charge value
  • Number of injections considered for knock limitation
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation - sport/race mode
  • Driver wish
  • Driver torque request
  • Maximum threshold for detecting engine knock - bank 1
  • Maximum threshold for detecting engine knock - bank 2
  • Throttle angle management
  • Variable intake pulsation correction

固件标识 (1)

硬件号软件号 (chip)版本升级软件ECU
026120134900419100C440 1.87.02600419100C440NM72 BOSCH ME7.8.2 min

ECU 说明

Microprocessor ST10F275 Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION!