PORSCHE BOXSTER (987) 2.7L 24V 180kW/241HP ME7.8.1

ECU BOSCH ME7.8.1 · 245 CV (18 kW) · 2700 cc · Benzina aspirato

ECU 数据库PORSCHE › PORSCHE BOXSTER (987) 2.7L 24V 180kW/241HP ME7.8.1

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 1 固件版本

车辆数据

品牌PORSCHE
型号BOXSTER (987)
发动机2.7L 24V 180kW/241HP ME7.8.1
原厂功率245 CV / 18 kW
排量2700 cc
燃料Benzina aspirato
车辆类型Auto

ECU

制造商BOSCH
型号ME7.8.1
存储 / EPROM29F800 PSOP44 8Mbit - Flash 512K x 16

可用的调校选项:

  • Base timing
  • Minimum advance allowed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • Factor to correct fuel delivery system 2
  • HFM/HLM air flow high limit
  • HFM/HLM air flow low limit
  • Lambda enrichment for components protection
  • Torque limiter at high EGT
  • Lambda efficiency
  • RPM Limiter
  • RPM limiter in Park position
  • Lambda driver wish
  • Knock detection factor
  • MAF sensor calibration
  • Maximum indicated torque
  • Maximum ignition delay allowed for knock limiter intervention
  • Maximum possible engine charge
  • Throttle air mass flow calculation
  • Minimum engine air charge value
  • Number of injections considered for knock limitation
  • Optimal engine moment
  • Offset tolerance depending on permissible torque
  • Relative permissible torque from the pedal position in torque limitation
  • Relative permissible torque from the pedal position in torque limitation - sport/race mode
  • Relative permissible torque from the pedal position in torque limitation - sport/race mode 2
  • Driver wish
  • Driver torque request
  • Driver torque request for reverse gear
  • Driver torque request Sport mode
  • Maximum threshold for detecting engine knock - bank 1
  • Maximum threshold for detecting engine knock - bank 2
  • Throttle angle management
  • Variable intake pulsation correction

固件标识 (1)

硬件号软件号 (chip)版本升级软件ECU
02612079871037379149 1.27.0050041900007605B18 BOSCH ME7.8.1

ECU 说明

Original EPROM PSOP 44 pins 29F800BB. In order to read this EPROM with the eprom programmer you need the adapter for PSOP and the card 15A with EMP20 or 202B with EMP21. ATTENTION !! ME7 ECU ! You can use the emulator ONLY to see the TRACE. MODIFY with the emulator ONLY with the engine OFF; DON'T modify with the engine ON. IX/LCP = INJECTION AT FULL LOAD, DECREASE VALUE TO INCREASE INJECTION! This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata