FIAT 500 (312) 1.4L 16V MULTIAIR 101kW/135HP IAW8GMKC — ECU MARELLI 8GMK/8GML

查找固件标识（硬件、软件和升级编号）、可用的调校选项，以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) ✓ 附加模块可用 2 固件版本

获取该车辆的文件

购买文件（原始或改写）在 mastertuningfile.com 注册并订购文件

车辆数据

品牌	FIAT
型号	500 (312)
发动机	1.4L 16V MULTIAIR 101kW/135HP IAW8GMKC
原厂功率	137 CV / 101 kW
排量	1400 cc
燃料	Benzina sovralimentato
车辆类型	Auto

ECU

制造商	MARELLI
型号	8GMK/8GML
存储 / EPROM	Micro BGA STSPC564A80 - 32748Kbit - 400000

可用的调校选项:

Base timing
Base lambda - cold
Base Lambda - hot
Boost pressure limiter
Electronic throttle control
Compressor pressure ratio limit for pumping and speed
Average power effective limitation
Average torque effective limitation
Torque limiter
Maximum Upstream pressure in event of Normal boost modality
Maximum Upstream pressure in event of normal boost modality, Offroad mode activated
Maximum Upstream pressure in event of normal boost modality, Sport mode activated
Maximum Upstream pressure in event of overboost modality
Maximum Upstream pressure in event of overboost modality, Offroad modality activated
Maximum Upstream pressure in event of overboost modality, Sport modality activated
Max torque profile
Torque management in Normal mode
Torque management Sport mode
Power Control in Normal mode
Power Control in Sport mode
Power limit torque table
Torque limit table for ECT sensor
Take-off torque law in Normal mode
Take-off torque law in Normal mode with power control
Take-off torque law in Sport mode
Take-off torque law in Sport mode with power control
Wastegate duty-cycle

固件标识 (2)

硬件号	软件号 (chip)	版本	升级软件	ECU
MM8GMKHW662	057005AI	1.91.010	057005AI	MARELLI 8GMK/8GML
MM8GMWHW640	03100000	1.91.008	68171042AC	MARELLI 8GMW

车辆技术说明

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU 说明

Microprocessor BGA SPC564A80 This Setting File can be used for serial system NewGenius. ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual. To work on this ECU you can use NewTrasdata

Microprocessor FMPC 5565 This Setting File can be used for serial system NewGenius. To work on this ECU you can use NewTrasdata ATTENTION: before proceding with any serial operation please read carefully the corresponding protocol serial manual.