CAN-AM/BRP SPYDER RT 1300 17->20 83kW

ECU BOSCH ME17.8.5 · 113 CV (83 kW) · 1300 cc · Benzina aspirato

ECU 数据库CAN-AM/BRP › CAN-AM/BRP SPYDER RT 1300 17->20 83kW

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 7 固件版本

车辆数据

品牌CAN-AM/BRP
型号SPYDER RT 1300
发动机17->20 83kW
原厂功率113 CV / 83 kW
排量1300 cc
燃料Benzina aspirato
车辆类型Moto

ECU

制造商BOSCH
型号ME17.8.5
存储 / EPROMMICRO ST TRICORE - 12032 Kbit - 178000

可用的调校选项:

  • Base timing
  • Lambda/AFR mixture for engine temperature at crancking
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Expected vehicle speed
  • ECT for fan disengagement
  • ECT for fan engagement
  • Injector latency - cylinder 1
  • Injector latency - cylinder 2
  • INJSC
  • Torque limiter
  • RPM Limiter
  • RPM Limiter 2
  • Gear dependent maximum engine speed
  • RPM limiter in limp mode
  • Maximum limitation Lambda sensor
  • Speed limiter - rear axle protection
  • Map sensor offset
  • MAP sensor slope
  • Max MAP sensor voltage
  • Throttle air mass flow calculation
  • Min MAP sensor voltage
  • Max allowed torque for speed limit control
  • Optimal engine moment
  • RPM hysteresis above rev limit for fuel cut-off
  • Driver torque request
  • Throttle angle management
  • Torque limit table for IAT sensor
  • Torque limit for voltage
  • Target Lambda for knock protection
  • Torque limit table for ECT sensor
  • Volumetric efficiency
  • RPM threshold for 2 foot
  • Vehicle speed threshold for 2 foot

固件标识 (7)

硬件号软件号 (chip)版本升级软件ECU
F00HM001817C1141OD6VMS2 1.94.012 BOSCH ME17.8.5
F00HM001817C1141OD5VMS5 1.94.003 BOSCH ME17.8.5
F00HM001967C1153OD6VMS1 1.94.006 BOSCH ME17.8.5
F00HM001967C1153OA7VKS1 1.94.003 BOSCH ME17.8.5
F00HM001967C1153OD6VKS1 1.94.004 BOSCH ME17.8.5
F00HM002127C1177OA7VMS2 1.94.003 BOSCH ME17.8.5
F00HM002127C1177OD6VMS3 1.94.006 BOSCH ME17.8.5

ECU 说明

MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata