ECU 数据库 ›
AUDI › AUDI S7 (4G8/C7) 4.0L V8 32V TFSI 331kW/444HP MED17.1.1
查找固件标识（硬件、软件和升级编号）、可用的调校选项，以及如何获取原始或改写文件。
✓ 通过文件调校 (flash)
✓ 附加模块可用 5 固件版本
车辆数据
| 品牌 | AUDI |
| 型号 | S7 (4G8/C7) |
| 发动机 | 4.0L V8 32V TFSI 331kW/444HP MED17.1.1 |
| 原厂功率 | 450 CV / 331 kW |
| 排量 | 4000 cc |
| 燃料 | Benzina sovralimentato |
| 车辆类型 | Auto |
ECU
| 制造商 | BOSCH |
| 型号 | MED17.1.1 |
| 存储 / EPROM | MICRO ST TRICORE - 32768 Kbit - 400000 |
可用的调校选项:
- Maximum air charge for overboost protection with turbocharger fault
- Base timing
- Advance at idle speed
- Optimal spark timing/MBT
- Boost pressure
- Height correction for boost pressure
- Desired engine load calculation
- Lambda correction for engine temperature after starting
- Desired pressure ratio
- Exhaust gas temperature
- Gearbox maximum torque allowed
- High pressure fuel pump setpoint
- High fuel pressure pump limit for ECT sensor
- Lambda enrichment for components protection
- Lambda correction for exhaust manifold temperature
- Lambda driver wish
- Knock detection factor
- Speed limiter
- Maximum indicated torque
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Optimal engine moment
- Power limit torque table
- Relative permissible torque from the pedal position in torque limitation
- Pressure ratio depending on IAT
- % relative air filling limit depending on IAT
- Driver torque request
- Throttle angle management
- Turbocharger volumetric efficiency
固件标识 (5)
| 硬件号 | 软件号 (chip) | 版本 | 升级软件 | ECU |
|---|
| — | — |
1.94.011 | 4G0906014C 0006 |
BOSCH MED17.1.1 |
| — | — |
1.00.016 | 4G0906014E 0004 |
BOSCH MED17.1.1 |
| — | — |
1.00.026 | 4G0906014D 0001 |
BOSCH MED17.1.1 |
| — | — |
1.94.010 | 4G0906014C 0004 |
BOSCH MED17.1.1 |
| — | — |
1.94.018 | 4G0906014C 0005 |
BOSCH MED17.1.1 |
车辆技术说明
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.
ECU 说明
MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
