AUDI S5 (B9) 3.0L V6 24V TFSI 260kW/348HP MG1CS002

ECU BOSCH MG1CS002 · 354 CV (26 kW) · 3000 cc · Benzina sovralimentato

ECU 数据库AUDI › AUDI S5 (B9) 3.0L V6 24V TFSI 260kW/348HP MG1CS002

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 12 固件版本

车辆数据

品牌AUDI
型号S5 (B9)
发动机3.0L V6 24V TFSI 260kW/348HP MG1CS002
原厂功率354 CV / 26 kW
排量3000 cc
燃料Benzina sovralimentato
车辆类型Auto

ECU

制造商BOSCH
型号MG1CS002
存储 / EPROMMicro BGA FREESCALE - 8192 Kbit - 800000

可用的调校选项:

  • Maximum air charge for overboost protection with turbocharger fault 2
  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Optimal spark timing/MBT 2
  • Boost pressure limiter 2
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Maximum torque limitation at clutch 2
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Max accepted exhaust gas temperature at exhaust manifold
  • Exhaust gas temperature
  • Maximum exhaust gas temperature GPF in regeneration mode for component protection
  • Exhaust valves lift
  • Filling factor limit
  • Filling factor limit 2
  • Factor for reducing maximum filling
  • Engine torque reducing factor depending on temperature
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Intake valve lift
  • L
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda minimum value for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Engine speed limit temperature based
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Maximum intake manifold pressure
  • Maximum throttle angle opening for a given RPM
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • Specific air mass charge - correction
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Throttle angle management
  • Target Lambda for knock protection
  • Torque limiter in recovery mode
  • Torque limiter in recovery mode 2
  • Torque limiter in recovery mode 3
  • Torque limiter in recovery mode 4
  • Torque limiter in recovery mode 6
  • Turbocharger volumetric efficiency

固件标识 (12)

硬件号软件号 (chip)版本升级软件ECU
1.02.0048W0907559H 0009 BOSCH MG1CS002
1.00.0108W0907559G 0009 BOSCH MG1CS002
1.02.0088W0907559G 0010 BOSCH MG1CS002
1.00.0058W0907559N 0002 BOSCH MG1CS002
1.02.0168W0907559G 0008 BOSCH MG1CS002
1.02.0108W0907559H 0008 BOSCH MG1CS002
1.02.0088W0907559G 0007 BOSCH MG1CS002
1.02.0078W0907559L 0002 BOSCH MG1CS002
1.02.0038W0907559G 0011 BOSCH MG1CS002
1.02.02880A907559D 0002 BOSCH MG1CS002
1.02.00780A907559C 0005 BOSCH MG1CS002
1.02.0068W0907559H 0007 BOSCH MG1CS002

ECU 说明

Microprocessor BGA FREESCALE SPC57xxx This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata