ECU 数据库 ›
AUDI › AUDI RSQ3 (8U) 2.5L 20V TFSI 250kW/340HP MED17.1.1
查找固件标识（硬件、软件和升级编号）、可用的调校选项，以及如何获取原始或改写文件。
✓ 通过文件调校 (flash)
✓ 附加模块可用 4 固件版本
车辆数据
| 品牌 | AUDI |
| 型号 | RSQ3 (8U) |
| 发动机 | 2.5L 20V TFSI 250kW/340HP MED17.1.1 |
| 原厂功率 | 340 CV / 25 kW |
| 排量 | 2500 cc |
| 燃料 | Benzina sovralimentato |
| 车辆类型 | Auto |
ECU
| 制造商 | BOSCH |
| 型号 | MED17.1.1 |
| 存储 / EPROM | MICRO ST TRICORE - 32768 Kbit - 400000 |
可用的调校选项:
- Base timing
- Advance at idle speed
- Optimal spark timing/MBT
- Boost pressure limit control
- Height correction for boost pressure
- Desired engine load calculation
- Lambda correction for engine temperature after starting
- Desired pressure ratio
- Exhaust gas temperature
- High pressure fuel pump setpoint
- High fuel pressure pump limit for ECT sensor
- Lambda enrichment for components protection
- RPM Limiter
- Boost pressure linearization
- Lambda driver wish
- Knock detection factor
- Speed limiter
- Maximum indicated torque (overboost active)
- Maximum boost pressure load
- Maximum boost pressure load 2
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Max torque profile
- Optimal engine moment
- Relative permissible torque from the pedal position in torque limitation
- Pressure ratio depending on IAT
- Maximum pressure ratio limit depending on temperature
- Driver torque request
- Torque limiter for selected gear
- Throttle angle management
固件标识 (4)
| 硬件号 | 软件号 (chip) | 版本 | 升级软件 | ECU |
|---|
| — | — |
1.00.010 | 8U0907404C 0003 |
BOSCH MED17.1.1 |
| — | — |
1.00.012 | 8U0907404B 0005 |
BOSCH MED17.1.1 |
| — | — |
1.00.002 | 8U0907404B 0006 |
BOSCH MED17.1.1 |
| — | — |
1.00.017 | 8U0907404C 0001 |
BOSCH MED17.1.1 |
车辆技术说明
OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.
ECU 说明
MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
