AUDI RS4 (B9) 2.9L TFSI 331kW/444HP MG1CS002

ECU BOSCH MG1CS002 · 450 CV (331 kW) · 2900 cc · Benzina sovralimentato

ECU 数据库AUDI › AUDI RS4 (B9) 2.9L TFSI 331kW/444HP MG1CS002

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) ✓ 附加模块可用 6 固件版本

车辆数据

品牌AUDI
型号RS4 (B9)
发动机2.9L TFSI 331kW/444HP MG1CS002
原厂功率450 CV / 331 kW
排量2900 cc
燃料Benzina sovralimentato
车辆类型Auto

ECU

制造商BOSCH
型号MG1CS002
存储 / EPROMMicro Infineon TRICORE categoria AURIX. Il micro ha una DFLASH da 848 Kbyte

可用的调校选项:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Optimal spark timing/MBT 2
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Torque limiter 2
  • Torque limiter 3
  • Torque limiter 4
  • Torque limiter 5
  • Torque limiter 6
  • Torque limiter 7
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Engine speed limit temperature based
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Maximum engine torque at crank shaft
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Turbocharger volumetric efficiency

固件标识 (6)

硬件号软件号 (chip)版本升级软件ECU
1.02.0068W0907551C 0002 BOSCH MG1CS002
1.02.0038W0907551 0006 BOSCH MG1CS002
1.00.0158W0907551F 0002 BOSCH MG1CS002
1.02.0358W0907551C 0001 BOSCH MG1CS002
1.02.0068W0907551 0008 BOSCH MG1CS002
1.02.0088W0907551 0007 BOSCH MG1CS002

ECU 说明

Microprocessor BGA FREESCALE SPC57xxx This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata