AUDI A8 (D4/4H) 4.2L V8 32V FSI 273kW/366HP MED17.1.1

ECU BOSCH MED17.1.1 · 371 CV (273 kW) · 4200 cc · Benzina aspirato

ECU 数据库AUDI › AUDI A8 (D4/4H) 4.2L V8 32V FSI 273kW/366HP MED17.1.1

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) ✓ 附加模块可用 6 固件版本

车辆数据

品牌AUDI
型号A8 (D4/4H)
发动机4.2L V8 32V FSI 273kW/366HP MED17.1.1
原厂功率371 CV / 273 kW
排量4200 cc
燃料Benzina aspirato
车辆类型Auto

ECU

制造商BOSCH
型号MED17.1.1
存储 / EPROMMICRO ST TRICORE - 16384 Kbit - 200000

可用的调校选项:

  • Engine ignition timing versus temperature
  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Engine speed limitation at high motor temperature
  • Engine speed limit temperature based
  • RPM limit for EOT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Throttle angle management

固件标识 (6)

硬件号软件号 (chip)版本升级软件ECU
1.94.0114H0907560 0007 BOSCH MED17.1.1
1.94.0274H0907560 0004 BOSCH MED17.1.1
1.94.0104H0907560C 0006 BOSCH MED17.1.1
1.94.0204H0907560C 0004 BOSCH MED17.1.1
1.94.0164H0907560 0006 BOSCH MED17.1.1
1.94.0094H0907560C 0005 BOSCH MED17.1.1

车辆技术说明

OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.

ECU 说明

MICRO Infineon Tricore TC1796 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. WARNING: this ECU can be modified ONLY with the BOOT system NewTrasdata or NewGenius flash_0313.
MICRO Infineon Tricore TC1796 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

可用附加模块

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):

→ See all add-on modules on the shop