ECU 数据库 ›
AUDI › AUDI A6 (C6/4F) 2.7L V6 24V TDI 120KW/161HP EDC16U31/CP34
查找固件标识（硬件、软件和升级编号）、可用的调校选项，以及如何获取原始或改写文件。
✓ 通过文件调校 (flash)
✓ 附加模块可用 2 固件版本
车辆数据
| 品牌 | AUDI |
| 型号 | A6 (C6/4F) |
| 发动机 | 2.7L V6 24V TDI 120KW/161HP EDC16U31/CP34 |
| 原厂功率 | 163 CV / 12 kW |
| 排量 | 2700 cc |
| 燃料 | Diesel sovralimentato |
| 车辆类型 | Auto |
ECU
可用的调校选项:
- Boost pressure limiter
- Maximum engine boost pressure F (atmospheric pressure)
- Boost pressure
- Boost pressure 2
- Maximum torque limitation at clutch
- Load / throttle position reference
- EGR valve control
- Exhaust gas temperature
- Protection for engine overheating
- Basic torque management at engine cranking
- Engine idle vs. ECT sensor
- Injection period
- Injection opening time related to inj. pressure
- J
- Torque limiter 2
- Lambda value of the smoke limitation
- Minimum LSU sensor temperature for O2
- Maximum LSU sensor temperature for O2
- LSU temperature threshold PID heater governor activation
- Protection for air load overheating
- Protection for fuel overheating
- Protection for oil overheating
- Specific injection pressure limiter
- Specific injection pressure
- Q
- Driver torque request
- Torque limiter for the 1st gear selected
- Torque limiter for the 2nd gear selected
- Torque limiter for the 3rd gear selected
- Torque limiter for the 4th gear selected
- Torque limiter for the 5th gear selected
- Torque limiter for the 6th gear selected
- Torque limiter for for reverse gear
- Torque limiter for the APS/BPS
- Torque limiter in recovery mode
- Turbocharger volumetric efficiency
- Variable geometry duty cycle limit
- Variable geometry duty cycle limit 2
固件标识 (2)
| 硬件号 | 软件号 (chip) | 版本 | 升级软件 | ECU |
|---|
| — | 1037382073 |
1.67.016 | 4F1910401C 0050 |
BOSCH EDC16U31/U34/CP34 |
| — | 1037380754 |
1.67.020 | 4F1910401A 0020 |
BOSCH EDC16U31/U34/CP34 |
车辆技术说明
OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.
ECU 说明
Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This Setting File can be used for serial system NewGenius. To modify this Ecu you can use the BDM system:555PRO or TRASDATA. WARNING:TRASDATA DO NOT need additional tools, 555PRO instead requires recalculation chks with VAG EDC16 CHECKSUM tool supplied with 555PRO, otherwise you will cause the block of the ecu or the detection of a change in the Ecu through diagnostic tool.
