AUDI A4 (B9/8W) 1.4L 16V TFSI 110kW/148 MED17.1.61

ECU BOSCH MED17.1.61 · 150 CV (11 kW) · 1400 cc · Benzina sovralimentato

ECU 数据库AUDI › AUDI A4 (B9/8W) 1.4L 16V TFSI 110kW/148 MED17.1.61

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 2 固件版本

车辆数据

品牌AUDI
型号A4 (B9/8W)
发动机1.4L 16V TFSI 110kW/148 MED17.1.61
原厂功率150 CV / 11 kW
排量1400 cc
燃料Benzina sovralimentato
车辆类型Auto

ECU

制造商BOSCH
型号MED17.1.61
存储 / EPROMMICRO ST TRICORE - 32768 - 400000

可用的调校选项:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Boost pressure limiter
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Desired pressure ratio
  • Maximum pressure ratio limit for diagnosis
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Gearbox maximum torque allowed
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Torque limiter
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • RPM limit for EOT sensor
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Pressure ratio depending on IAT
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Driver torque request 2
  • Torque limiter for selected gear
  • Setpoint maximum turbocharger speed
  • Throttle angle management

固件标识 (2)

硬件号软件号 (chip)版本升级软件ECU
1.94.01104E906022B 4032 BOSCH MED17.1.61
1.94.00904E906022 2848 BOSCH MED17.1.61

ECU 说明

MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation.