AUDI A1 (GB) 30 1.0L 12V TFSI 85kW/114HP MED17.1.27

ECU BOSCH MED17.1.27 · 116 CV (85 kW) · 1000 cc · Benzina sovralimentato

ECU 数据库AUDI › AUDI A1 (GB) 30 1.0L 12V TFSI 85kW/114HP MED17.1.27

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) ✓ 附加模块可用 3 固件版本

车辆数据

品牌AUDI
型号A1 (GB)
发动机30 1.0L 12V TFSI 85kW/114HP MED17.1.27
原厂功率116 CV / 85 kW
排量1000 cc
燃料Benzina sovralimentato
车辆类型Auto

ECU

制造商BOSCH
型号MED17.1.27
存储 / EPROMMICRO ST TRICORE - 32768 - 400000

可用的调校选项:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Boost pressure limiter
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Engine idle vs. ECT sensor
  • Gearbox maximum torque allowed
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • Knock detection factor
  • Speed limiter
  • Maximum compression ratio
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management

固件标识 (3)

硬件号软件号 (chip)版本升级软件ECU
1.94.00804C906025BF 7261 BOSCH MED17.1.27
1.94.01004C906025H 5177 BOSCH MED17.1.27
1.94.00804C906025M 6196 BOSCH MED17.1.27

车辆技术说明

OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.

ECU 说明

MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata