VOLKSWAGEN TIGUAN Mk2 1.5L L4 16V TSI 110kW/148HP DSG DQ38X

ECU BOSCH DQ381 · 150 CV (11 kW) · 1500 cc · Benzina sovralimentato

ECU 数据库VOLKSWAGEN › VOLKSWAGEN TIGUAN Mk2 1.5L L4 16V TSI 110kW/148HP DSG DQ38X

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 1 固件版本

车辆数据

品牌VOLKSWAGEN
型号TIGUAN Mk2
发动机1.5L L4 16V TSI 110kW/148HP DSG DQ38X
原厂功率150 CV / 11 kW
排量1500 cc
燃料Benzina sovralimentato
车辆类型Auto

ECU

制造商BOSCH
型号DQ381
存储 / EPROMMicro Renesas - 20480 Kbit

可用的调校选项:

  • Gear upshift 1->2
  • Gear upshift 2->3
  • Maximum time for gear downshift
  • Time shift
  • Time shift with torque reduction
  • Time shift with torque reduction 2
  • Engagement time for gear overlap
  • Maximum torque limitation at clutch
  • Clutch torque reduction factor
  • Gearbox torque limiter
  • Gearbox torque limiter 2
  • Maximum torque reduction in ECO (D)
  • Maximum torque reduction during launch control
  • Maximum torque reduction in MANUAL
  • Maximum torque reduction in SPORT (S)
  • RPM limiter
  • RPM limiter - N
  • RPM limiter - R
  • Maximum torque allowed for gear upshift
  • Gearbox torque limiter for ECT sensor
  • Engine torque limiter depending on vehicle speed
  • Maximum allowable oil pressure
  • Maximum oil pressure allowed at the clutch
  • Maximum upshifting time for 2 gears
  • Maximum upshifting time for 3 gears
  • Maximum upshifting time for 4 gears
  • Maximum upshifting time for 5 gears
  • Oil pressure during adaptations
  • Oil pressure correction based on TOT
  • Oil pressure correction based on TOT 2
  • Gear based pressure verification
  • Gear upshift 1->2 - recovery
  • Gear upshift 2 and higher 1->2 - recovery
  • RPM for the engine stall with ESP OFF
  • Shift time with torque reduction
  • Shift time with torque reduction 2
  • Shift timing for gear downshift without load
  • Vehicle speed target for gear shift

固件标识 (1)

硬件号软件号 (chip)版本升级软件ECU
0GC300048K 1.94.0120GC300048K 2804 BOSCH DQ381

ECU 说明

Microprocessor SH72549 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata