YAMAHA MOTORCYCLES T?n?r? 700 25->25 55kW
ECU DENSO Bxx-8591A-xx · 73 CV (54 kW) · 690 cc · Benzina aspirato
ECU duomenų bazė ›
YAMAHA MOTORCYCLES › YAMAHA MOTORCYCLES T?n?r? 700 25->25 55kW
Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
5 programinės įrangos versijos
Gaukite failą šiai transporto priemonei
Transporto priemonės duomenys
| Markė | YAMAHA MOTORCYCLES |
| Modelis | T?n?r? 700 |
| Variklis | 25->25 55kW |
| Serijinė galia | 73 CV / 54 kW |
| Darbinis tūris | 690 cc |
| Kuras | Benzina aspirato |
| Transporto priemonės tipas | Moto |
ECU
| Gamintojas | DENSO |
| Modelis | Bxx-8591A-xx |
| Atmintis / EPROM | Micro RENESAS core RH850 |
Galimos derinimo operacijos / parinktys:
- AFR full load/WOT
- AFR for IAP
- AFR for TPS
- Base timing
- Optimal spark timing/MBT
- Advance correction
- Coil charge time
- Engine idle vs. ECT sensor
- Rpm threshold fuel cut
- Rpm threshold fuel cut 2
- Injection for IAP
- Injection for TPS
- RPM Limiter
- Speed limiter
- Optimal engine moment
- Optimal engine moment 2
- Throttle angle limitation
- TAMCM
- Throttle angle management - correction - mode 2
- Throttle angle management - correction - mode 3
- Throttle angle management - correction - mode 4
- TAMM
- Cooling fan activation
- Engine torque limiter depending on vehicle speed
Programinės įrangos identifikatoriai (5)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|---|---|---|---|
| — | 14008000 | 1.00.014 | D081_14008000 | DENSO Bxx-8591A-xx |
| — | 1289C000 | 1.00.004 | BRL3_1289C000 | DENSO Bxx-8591A-xx |
| — | 14007001 | 1.00.007 | D071_14007001 | DENSO Bxx-8591A-xx |
| — | 14008000 | 1.00.022 | D081_14008000 | DENSO Bxx-8591A-xx |
| — | 14008040 | 1.00.013 | D082_14008040 | DENSO Bxx-8591A-xx |
ECU pastabos
Microprocessor R7F701201 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor R7F701201 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata ATTENTION - 35kW reduced power version file.
