VOLKSWAGEN CC 1.4L 16V TSI 118kW/158HP MED17.1

ECU BOSCH MED17.1 · 160 CV (118 kW) · 1400 cc · Benzina sovralimentato

ECU duomenų bazėVOLKSWAGEN › VOLKSWAGEN CC 1.4L 16V TSI 118kW/158HP MED17.1

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 2 programinės įrangos versijos

Transporto priemonės duomenys

MarkėVOLKSWAGEN
ModelisCC
Variklis1.4L 16V TSI 118kW/158HP MED17.1
Serijinė galia160 CV / 118 kW
Darbinis tūris1400 cc
KurasBenzina sovralimentato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMED17.1
Atmintis / EPROMMICRO ST TRICORE - 16384 Kbit - 200000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Boost pressure limiter
  • Boost pressure
  • Height correction for boost pressure
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for EOT sensor
  • Lambda driver wish
  • Knock detection factor
  • Intake manifold pressure
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Driver torque request
  • Throttle angle management

Programinės įrangos identifikatoriai (2)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.94.01203C906021M 9971 BOSCH MED17.1
1.94.00403C906021M 9658 BOSCH MED17.1

ECU pastabos

MICRO Infineon Tricore TC1796 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata