TOYOTA WISH (AE20) 2.0L 16V 116kW/157HP DENSO

ECU DENSO 275922-3410 · 158 CV (116 kW) · 2000 cc · Benzina aspirato

ECU duomenų bazėTOYOTA › TOYOTA WISH (AE20) 2.0L 16V 116kW/157HP DENSO

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 2 programinės įrangos versijos

Transporto priemonės duomenys

MarkėTOYOTA
ModelisWISH (AE20)
Variklis2.0L 16V 116kW/157HP DENSO
Serijinė galia158 CV / 116 kW
Darbinis tūris2000 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasDENSO
Modelis275922-3410
Atmintis / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(IAT) 2
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Lambda correction f(ECT) 3
  • Lambda correction f(ECT) 4
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor

Programinės įrangos identifikatoriai (2)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
89663-0M022- 1.67.00330M02200 DENSO 275922-3410
89663-0M020- 1.67.02230M02000 DENSO 275922-3410

Techninės pastabos apie automobilį

OBD located under the steering column, above the pedals. Visible or hidden by a plastic lid.

ECU pastabos

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata