TOYOTA LAND CRUISER PRADO (J150) 2.7L 16V VVT-i 117kW/157HP DENSO

ECU DENSO 275036-7400/7470 · 159 CV (117 kW) · 2700 cc · Benzina aspirato

ECU duomenų bazėTOYOTA › TOYOTA LAND CRUISER PRADO (J150) 2.7L 16V VVT-i 117kW/157HP DENSO

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėTOYOTA
ModelisLAND CRUISER PRADO (J150)
Variklis2.7L 16V VVT-i 117kW/157HP DENSO
Serijinė galia159 CV / 117 kW
Darbinis tūris2700 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasDENSO
Modelis275036-7400/7470
Atmintis / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Torque limiter 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
89663-60S50- 1.67.010360S5000 DENSO 275036-7400/7470

ECU pastabos

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata