TOYOTA BELTA (XP90) 1.3L 16V VVT-i 64kW/87HP DENSO

ECU DENSO 275036-1152 · 87 CV (64 kW) · 1300 cc · Benzina aspirato

ECU duomenų bazėTOYOTA › TOYOTA BELTA (XP90) 1.3L 16V VVT-i 64kW/87HP DENSO

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 2 programinės įrangos versijos

Transporto priemonės duomenys

MarkėTOYOTA
ModelisBELTA (XP90)
Variklis1.3L 16V VVT-i 64kW/87HP DENSO
Serijinė galia87 CV / 64 kW
Darbinis tūris1300 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasDENSO
Modelis275036-1152
Atmintis / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Galimos derinimo operacijos / parinktys:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet

Programinės įrangos identifikatoriai (2)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
89663-52G00- 1.67.002352G0000 DENSO 275036-1152
89663-52M00- 1.67.008352M0000 DENSO 275036-1152

ECU pastabos

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata