TOYOTA AURIS (E180) 1.8L 16V VVT-i 100kW/134HP DENSO

ECU DENSO 275036-7400/7470 · 136 CV (1 kW) · 1800 cc · Benzina aspirato

ECU duomenų bazėTOYOTA › TOYOTA AURIS (E180) 1.8L 16V VVT-i 100kW/134HP DENSO

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 2 programinės įrangos versijos

Transporto priemonės duomenys

MarkėTOYOTA
ModelisAURIS (E180)
Variklis1.8L 16V VVT-i 100kW/134HP DENSO
Serijinė galia136 CV / 1 kW
Darbinis tūris1800 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasDENSO
Modelis275036-7400/7470
Atmintis / EPROMMICRO NEC 76F0085 - 8192 Kbit - 100000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(IAT) 2
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Advance limiter for component protection 1
  • Basic value setpoint Lambda sensor
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Exhaust gas temperature sensor 3
  • Variable valve timing - inlet

Programinės įrangos identifikatoriai (2)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
89663-12850-B 1.51.00931285000 DENSO 275036-7400/7470
89663-12190- 1.51.00231219000 DENSO 275136-2010

ECU pastabos

Microprocessor NEC 76F0085 This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Microprocessor NEC 76F0038AGD To work on this ECU you can use NewTrasdata