SEAT LEON (5F) 1.0L 12V TSI 85kW/114HP MED17.1.27

ECU BOSCH MED17.1.27 · 116 CV (85 kW) · 1000 cc · Benzina sovralimentato

ECU duomenų bazėSEAT › SEAT LEON (5F) 1.0L 12V TSI 85kW/114HP MED17.1.27

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėSEAT
ModelisLEON (5F)
Variklis1.0L 12V TSI 85kW/114HP MED17.1.27
Serijinė galia116 CV / 85 kW
Darbinis tūris1000 cc
KurasBenzina sovralimentato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMED17.1.27
Atmintis / EPROMMICRO ST TRICORE - 32768 - 400000

Galimos derinimo operacijos / parinktys:

  • Maximum air charge for overboost protection with turbocharger fault
  • Base timing
  • Optimal spark timing/MBT
  • Boost pressure limiter
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor for reducing maximum filling
  • Engine idle vs. ECT sensor
  • Gearbox maximum torque allowed
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • RPM limiter 3
  • Knock detection factor
  • Speed limiter
  • Maximum compression ratio
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.94.00604C906025BA 7059 BOSCH MED17.1.27

ECU pastabos

MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata