PORSCHE PANAMERA (971) 4S 2.9L V6 24V TFSI 324kW/434HP MG1CS002

ECU BOSCH MG1CS002 · 441 CV (324 kW) · 2900 cc · Benzina sovralimentato

ECU duomenų bazėPORSCHE › PORSCHE PANAMERA (971) 4S 2.9L V6 24V TFSI 324kW/434HP MG1CS002

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) ✓ Galimas papildomas modulis 3 programinės įrangos versijos

Transporto priemonės duomenys

MarkėPORSCHE
ModelisPANAMERA (971)
Variklis4S 2.9L V6 24V TFSI 324kW/434HP MG1CS002
Serijinė galia441 CV / 324 kW
Darbinis tūris2900 cc
KurasBenzina sovralimentato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMG1CS002
Atmintis / EPROMMicro BGA FREESCALE - 8192 Kbit - 800000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Exhaust gas temperature
  • Filling factor limit
  • Filling factor limit 2
  • Factor for reducing maximum filling
  • Torque limiter 2
  • Torque limiter 3
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management

Programinės įrangos identifikatoriai (3)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.02.006971907551A 0004 BOSCH MG1CS002
1.02.009971907551 0007 BOSCH MG1CS002
1.02.006971907551L 0002 BOSCH MG1CS002

ECU pastabos

Microprocessor BGA FREESCALE SPC57xxx This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata

Galimi papildomi moduliai

A plug-and-play add-on module is available for this vehicle (as an alternative or in addition to the file):