PORSCHE 991.2 4.0L GT3 RS 382kW/512HP MED17.1.11

ECU BOSCH MED17.1.11 · 519 CV (382 kW) · 4000 cc · Benzina aspirato

ECU duomenų bazėPORSCHE › PORSCHE 991.2 4.0L GT3 RS 382kW/512HP MED17.1.11

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 5 programinės įrangos versijos

Transporto priemonės duomenys

MarkėPORSCHE
Modelis991.2
Variklis4.0L GT3 RS 382kW/512HP MED17.1.11
Serijinė galia519 CV / 382 kW
Darbinis tūris4000 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMED17.1.11
Atmintis / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • Lambda driver wish
  • Knock detection factor
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Power limit torque table
  • Relative permissible torque from the pedal position in torque limitation
  • Driver torque request
  • Driver torque request 2
  • Torque limiter for selected gear
  • Throttle angle management

Programinės įrangos identifikatoriai (5)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.94.00699161866108 3648 BOSCH MED17.1.11
1.94.00399161866109 3680 BOSCH MED17.1.11
1.94.00599161866209 3681 BOSCH MED17.1.11
1.94.00399161866408 3651 BOSCH MED17.1.11
1.94.00399161866309 3682 BOSCH MED17.1.11

ECU pastabos

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata