Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
1 programinės įrangos versijos
Transporto priemonės duomenys
| Markė | PEUGEOT |
| Modelis | 4008 |
| Variklis | 1.6L 16V HDI 85kW/114HP SID807EVO |
| Serijinė galia | 116 CV / 85 kW |
| Darbinis tūris | 1600 cc |
| Kuras | Diesel sovralimentato |
| Transporto priemonės tipas | Auto |
ECU
| Gamintojas | CONTINENTAL-SIEMENS-VDO |
| Modelis | SID807EVO |
| Atmintis / EPROM | MICRO ST TRICORE - 32768 Kbit - 400000 |
Galimos derinimo operacijos / parinktys:
- Boost pressure limiter for diagnostics
- Boost pressure limiter
- BAP setpoint limitation depending on before particulate filter pressure in aftertreatment modes
- Boost pressure
- Boost pressure 2
- Boost pressure 3
- Boost pressure 4
- Load / throttle position reference
- Exhaust gas temperature value before turbine in regeneration mode
- Exhaust gas temperature value before turbine in regular injection mode
- Basic torque management at engine cranking
- Injection opening time related to inj. pressure
- J
- Torque limiter 2
- Torque limiter
- Intake manifold pressure
- Throttle air mass flow calculation
- Throttle air mass flow calculation 2
- Max torque profile
- Specific injection pressure limiter
- Specific injection pressure
- Driver torque request for high speed
- Driver torque request for medium speed
- Driver torque request for low speed
- Driver torque request at the start
- Driver torque request for reverse gear
- Torque limiter for EFT sensor
- Torque limit table for ECT sensor
- Variable geometry duty cycle limit
Programinės įrangos identifikatoriai (1)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|
| 9675411580 | 9678226080 |
1.83.011 | 9692020480 |
CONTINENTAL-SIEMENS-VDO SID807EVO |
Techninės pastabos apie automobilį
OBD located to the left of the driver's side, under the steering column and behind the bulkhead or the lid in the fuse box area.
ECU pastabos
MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Gaukite failą šiai transporto priemonei
Tools to read and write this ECU
