MERCEDES E CLASS W212/S212 E350 3.5L V6 225kW/302HP ME9.7

ECU BOSCH ME9.7 · 306 CV (225 kW) · 3500 cc · Benzina aspirato

ECU duomenų bazėMERCEDES › MERCEDES E CLASS W212/S212 E350 3.5L V6 225kW/302HP ME9.7

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėMERCEDES
ModelisE CLASS W212/S212
VariklisE350 3.5L V6 225kW/302HP ME9.7
Serijinė galia306 CV / 225 kW
Darbinis tūris3500 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisME9.7
Atmintis / EPROMM58BW016DB PQFP80 - Flash 3_V 512 x 32

Galimos derinimo operacijos / parinktys:

  • Base timing
  • Advance at idle speed
  • Optimal spark timing/MBT
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Exhaust gas temperature
  • Factor to correct fuel delivery system
  • HFM/HLM threshold for diagnosis
  • Lambda enrichment for components protection
  • Lambda correction for exhaust manifold temperature
  • RPM Limiter
  • RPM Limiter 2
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Max torque profile
  • Optimal engine moment
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Throttle angle management
  • Variable intake pulsation correction

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
00344677402729020000 1.79.0029A567C9FD0 BOSCH ME9.7

ECU pastabos

Original EPROM ST M58BW016DB PQFP 80 Pin - Microprocessor Motorola MPC561/2/3/4. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata