LEXUS ES (XV40) ES350 3.5L 204kW/274HP DENSO 275030

ECU DENSO 275036-2110 · 277 CV (204 kW) · 3500 cc · Benzina aspirato

ECU duomenų bazėLEXUS › LEXUS ES (XV40) ES350 3.5L 204kW/274HP DENSO 275030

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 2 programinės įrangos versijos

Transporto priemonės duomenys

MarkėLEXUS
ModelisES (XV40)
VariklisES350 3.5L 204kW/274HP DENSO 275030
Serijinė galia277 CV / 204 kW
Darbinis tūris3500 cc
KurasBenzina aspirato
Transporto priemonės tipasAuto

ECU

GamintojasDENSO
Modelis275036-2110
Atmintis / EPROMMICRO NEC 76F0038AGD - 6144 Kbit - C0000

Galimos derinimo operacijos / parinktys:

  • Spark advance correction for ECT sensor
  • Requested spark advance - high octane
  • Requested spark advance - low octane
  • Spark advance correction - valve timing position 1
  • Spark advance correction - valve timing position 2
  • Electronic throttle control
  • Electronic throttle control 2
  • Electronic throttle control 3
  • Lambda correction f(IAT)
  • Lambda correction f(ECT)
  • Lambda correction f(ECT) 2
  • Lambda correction f(ECT) 3
  • Gearbox maximum torque allowed
  • Advance limiter for component protection 1
  • Torque limiter
  • Lambda enrichment - open loop
  • RPM Limiter
  • Lambda driver wish
  • Speed limiter
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Exhaust gas temperature sensor
  • Variable valve timing - inlet
  • Variable valve timing - outlet

Programinės įrangos identifikatoriai (2)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
89663-33752- 1.51.00433375200 DENSO 275036-2110
89663-33781- 1.51.00633378100 DENSO 275036-2110

ECU pastabos

Microprocessor NEC 76F0038AGD This Setting File can be used for serial system NewGenius. This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata