CAN-AM/BRP RENEGADE 1000 18->21 60kW
ECU BOSCH ME17.8.5 · 82 CV (6 kW) · 1000 cc · Benzina aspirato
ECU duomenų bazė ›
CAN-AM/BRP › CAN-AM/BRP RENEGADE 1000 18->21 60kW
Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
2 programinės įrangos versijos
Gaukite failą šiai transporto priemonei
Transporto priemonės duomenys
| Markė | CAN-AM/BRP |
| Modelis | RENEGADE 1000 |
| Variklis | 18->21 60kW |
| Serijinė galia | 82 CV / 6 kW |
| Darbinis tūris | 1000 cc |
| Kuras | Benzina aspirato |
| Transporto priemonės tipas | Moto |
ECU
| Gamintojas | BOSCH |
| Modelis | ME17.8.5 |
| Atmintis / EPROM | MICRO ST TRICORE - 12032 Kbit - 178000 |
Galimos derinimo operacijos / parinktys:
- Base timing
- Lambda/AFR mixture for engine temperature at crancking
- Optimal spark timing/MBT
- Desired engine load calculation
- Lambda correction for engine temperature after starting
- Expected vehicle speed
- ECT for fan disengagement
- ECT for fan engagement
- Injector latency - cylinder 1
- Injector latency - cylinder 2
- Torque limiter
- Lambda enrichment for components protection
- RPM Limiter
- RPM Limiter 2
- Gear dependent maximum engine speed
- RPM limiter in limp mode
- Maximum limitation Lambda sensor
- Speed limiter based on gear
- Speed limiter for key
- Speed limiter - rear axle protection
- Speed limiter for unknown gear
- Map sensor offset
- MAP sensor slope
- Max MAP sensor voltage
- Throttle air mass flow calculation
- Min MAP sensor voltage
- Optimal engine moment
- RPM hysteresis above rev limit for fuel cut-off
- Driver torque request
- Throttle angle management
- Torque limit table for IAT sensor
- Torque limit for voltage
- Target Lambda for knock protection
- Torque limit table for ECT sensor
- Volumetric efficiency
- RPM threshold for 2 foot
- Vehicle speed threshold for 2 foot
Programinės įrangos identifikatoriai (2)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|---|---|---|---|
| F00HM00196 | 7E5193NF3VXS2 | 1.94.018 | — | BOSCH ME17.8.5 |
| F00HM00196 | 7E5173NH3VXS3 | 1.94.003 | — | BOSCH ME17.8.5 |
ECU pastabos
MICRO Infineon Tricore TC1766 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
