ECU duomenų bazė ›
BMW › BMW 2 SERIES F22/F23/F44/F45/F46 220i 2.0L L4 16V 120kW/161HP MEVD17.2.3
Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
✓ Galimas papildomas modulis 2 programinės įrangos versijos
Transporto priemonės duomenys
| Markė | BMW |
| Modelis | 2 SERIES F22/F23/F44/F45/F46 |
| Variklis | 220i 2.0L L4 16V 120kW/161HP MEVD17.2.3 |
| Serijinė galia | 163 CV / 12 kW |
| Darbinis tūris | 2000 cc |
| Kuras | Benzina sovralimentato |
| Transporto priemonės tipas | Auto |
ECU
| Gamintojas | BOSCH |
| Modelis | MEVD17.2.3 |
| Atmintis / EPROM | MICRO ST TRICORE - 32768 - 400000 |
Galimos derinimo operacijos / parinktys:
- Spark advance correction for soundtuning - nomal mode
- Spark advance correction for soundtuning - sport mode
- Base timing
- Minimum advance allowed protection - motore caldo
- Lambda/AFR full load/WOT
- Lambda/AFR mixture at part load
- Optimal spark timing/MBT
- Optimal spark timing/MBT - emergency
- Boost pressure limiter - advance correction
- Boost pressure limiter - advance correction 2
- Boost pressure limiter for diagnostics
- Boost pressure limiter for diagnostics 2
- Maximum torque limitation at clutch
- Correction for boost pressure
- Driver torque limit for clutch protection
- Compression ratio for turbocharger protection
- Engine torque reducing factor depending on engine speed
- Engine torque reducing factor depending on temperature
- HFM/HLM threshold for diagnosis
- High pressure fuel pump setpoint
- High pressure fuel pump setpoint - cold condition
- High pressure fuel pump setpoint - full load
- High pressure fuel pump setpoint - limp home mode
- Intake pressure protection
- Intake valve lift
- Intake valve lift - cold
- Intake valve lift - cold 3
- Intake valve lift - limit
- Intake valve lift - warm
- Intake valve lift - warm 2
- Torque limiter 2
- Advance limiter - emergency
- Basic value Lambda sensor
- Lambda target value
- Torque limiter
- Torque limiter - AT
- Torque limiter in full load
- Lambda enrichment - open loop
- Lambda minimum value for components protection
- RPM Limiter
- RPM Limiter 2
- RPM limit for ECT sensor
- RPM limit for EOT sensor
- Knock detection factor
- Maximum absolute effective torque
- Maximum indicated torque
- Maximum indicated torque for monitoring
- Maximum boost pressure load
- Throttle air mass flow calculation
- Maximum rail pressure at start-up
- Optimal engine moment
- Pressure ratio depending on IAT
- Maximum pressure ratio limit depending on temperature
- Maximum pressure ratio limit depending on ECT
- Specific pressure injection after starting
- Turbo pressure variation control factor
- Driver torque request
- Driver torque request for low speed
- Maximum threshold for detecting engine knock
- Start of injection
- Maximum upper tolerance intake pressure protection
- Lower pressure control threshold
- Theoretical maximum engine power
- Turbo pressure sensor - lower threshold
- Upper engine rpm threshold for diagnostic control
- Upper pressure control threshold
- Wastegate duty-cycle
Programinės įrangos identifikatoriai (2)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|
| 0000208C024505 | 0000360A952801 |
1.94.006 | 00005530952801 |
BOSCH MEVD17.2.3 |
| 0000208C024505 | 0000360A952801 |
1.94.003 | 00003C16952802 |
BOSCH MEVD17.2.3 |
Techninės pastabos apie automobilį
OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.
ECU pastabos
MICRO Infineon Tricore TC1793 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Gaukite failą šiai transporto priemonei
Tools to read and write this ECU
