AUDI TT (8S/FV) 40 2.0L 16V TFSI 145kW/194HP MG1CS111

ECU BOSCH MG1CS001/MG1CS111 · 197 CV (145 kW) · 2000 cc · Benzina sovralimentato

ECU duomenų bazėAUDI › AUDI TT (8S/FV) 40 2.0L 16V TFSI 145kW/194HP MG1CS111

Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.

✓ Derinimas failu (flash) 1 programinės įrangos versijos

Transporto priemonės duomenys

MarkėAUDI
ModelisTT (8S/FV)
Variklis40 2.0L 16V TFSI 145kW/194HP MG1CS111
Serijinė galia197 CV / 145 kW
Darbinis tūris2000 cc
KurasBenzina sovralimentato
Transporto priemonės tipasAuto

ECU

GamintojasBOSCH
ModelisMG1CS001/MG1CS111
Atmintis / EPROMMicro BGA FREESCALE - 8192 Kbit - 800000

Galimos derinimo operacijos / parinktys:

  • Maximum air charge for overboost protection with turbocharger fault
  • Maximum air charge for overboost protection with turbocharger fault 2
  • Base timing
  • Advance at idle speed
  • Advance at idle speed 2
  • Advance at idle speed 3
  • Optimal spark timing/MBT
  • Optimal spark timing/MBT 2
  • Boost pressure limiter
  • Boost pressure limiter 2
  • Desired engine load calculation
  • Lambda correction for engine temperature after starting
  • Maximum torque limitation at clutch
  • Maximum torque limitation at clutch 2
  • Compression ratio for turbocharger protection
  • Compression ratio limiting for compressor depending on IAT sensor
  • Maximum pressure ratio limit for diagnosis
  • Max accepted exhaust gas temperature at exhaust manifold
  • Exhaust gas temperature
  • Maximum exhaust gas temperature GPF in regeneration mode for component protection
  • Exhaust valves lift
  • Weighting map cold-start
  • Max torque correction factor for ECT sensor
  • Filling factor limit
  • Factor for reducing maximum filling
  • Engine torque reducing factor depending on temperature
  • Max CAT temperature threshold for component protection
  • HFM/HLM air flow high limit
  • High pressure fuel pump setpoint
  • High fuel pressure pump limit for ECT sensor
  • High fuel pressure pump limit
  • Intake valve lift
  • Torque limiter 2
  • L
  • Torque limiter
  • Lambda enrichment for components protection
  • Lambda value for components protection activation
  • Lambda correction for exhaust manifold temperature
  • RPM limiter - N
  • RPM limiter in Park position
  • RPM limit for ECT sensor
  • Driver torque request limiter
  • Knock detection factor
  • Speed limiter
  • MAF sensor calibration
  • Maximum indicated torque
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Maximum intake manifold pressure
  • Maximum relative engine air charge
  • Maximum throttle angle opening for a given RPM
  • Max torque profile
  • Optimal engine moment
  • Power limit torque table
  • Turbo pressure variation control factor
  • Turbo pressure variation control factor 2
  • Turbo pressure variation control factor 3
  • Specific air mass charge - correction
  • % relative air filling limit depending on IAT
  • Driver torque request
  • Setpoint maximum turbocharger speed
  • Throttle angle management
  • Target Lambda for knock protection
  • Torque limiter in recovery mode
  • Torque limiter in recovery mode 2
  • Torque limiter in recovery mode 3
  • Torque limiter in recovery mode 4
  • Torque limiter in recovery mode 5
  • Torque limiter in recovery mode 6

Programinės įrangos identifikatoriai (1)

Aparatinės įrangos Nr.Programinės įrangos Nr. (lustas)VersijaAtnaujinimo programinė įrangaECU
1.02.0148S0907115 0003 BOSCH MG1CS001/MG1CS111

ECU pastabos

Microprocessor BGA FREESCALE SPC57xxx This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata