Raskite programinės įrangos identifikatorius (aparatinės, programinės įrangos ir atnaujinimo numerius), galimas derinimo parinktis ir kaip gauti originalų arba perprogramuotą failą.
✓ Derinimas failu (flash)
✓ Galimas papildomas modulis 2 programinės įrangos versijos
Transporto priemonės duomenys
| Markė | AUDI |
| Modelis | A6 (C7/4G) |
| Variklis | 2.0L 16V TFSI 155kW/208HP MED17.1.1 |
| Serijinė galia | 211 CV / 155 kW |
| Darbinis tūris | 2000 cc |
| Kuras | Benzina sovralimentato |
| Transporto priemonės tipas | Auto |
ECU
| Gamintojas | BOSCH |
| Modelis | MED17.1.1 |
| Atmintis / EPROM | MICRO ST TRICORE - 32768 Kbit - 400000 |
Galimos derinimo operacijos / parinktys:
- Base timing
- Optimal spark timing/MBT
- Boost pressure limiter 4
- Height correction for boost pressure
- Desired engine load calculation
- Lambda correction
- Desired pressure ratio
- Maximum pressure ratio limit for diagnosis
- Exhaust gas temperature
- High pressure fuel pump setpoint
- High fuel pressure pump limit for ECT sensor
- Lambda enrichment for components protection
- Lambda correction for exhaust manifold temperature
- Lambda driver wish
- Knock detection factor
- Maximum boost pressure load
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Max torque profile
- Max torque profile - AT
- Optimal engine moment
- Relative permissible torque from the pedal position in torque limitation
- Pressure ratio depending on IAT
- Driver torque request
- Throttle angle management
Programinės įrangos identifikatoriai (2)
| Aparatinės įrangos Nr. | Programinės įrangos Nr. (lustas) | Versija | Atnaujinimo programinė įranga | ECU |
|---|
| — | — |
1.94.003 | 4G0907115D 0005 |
BOSCH MED17.1.1 |
| — | — |
1.94.014 | 4G0907115D 0004 |
BOSCH MED17.1.1 |
Techninės pastabos apie automobilį
OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.
ECU pastabos
MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
Gaukite failą šiai transporto priemonei
Tools to read and write this ECU
