ECU 数据库 ›
BMW › BMW 5 SERIES F10/F11/F18 523i 2.0L L4 16V 150kW/201HP MEVD17.2.4
查找固件标识（硬件、软件和升级编号）、可用的调校选项，以及如何获取原始或改写文件。
✓ 通过文件调校 (flash)
✓ 附加模块可用 2 固件版本
车辆数据
| 品牌 | BMW |
| 型号 | 5 SERIES F10/F11/F18 |
| 发动机 | 523i 2.0L L4 16V 150kW/201HP MEVD17.2.4 |
| 原厂功率 | 204 CV / 15 kW |
| 排量 | 2000 cc |
| 燃料 | Benzina aspirato |
| 车辆类型 | Auto |
ECU
| 制造商 | BOSCH |
| 型号 | MEVD17.2.4 |
| 存储 / EPROM | MICRO ST TRICORE - 32768 Kbit - 400000 |
可用的调校选项:
- Base timing
- Optimal spark timing/MBT
- Boost pressure
- Boost pressure 2
- Desired engine load calculation
- Maximum torque limitation at clutch
- Characteristic line correction factor for pressure ratio for turbocharger overspeed protection
- Gearbox maximum torque allowed
- HFM/HLM threshold for diagnosis
- High pressure fuel pump setpoint
- Intake valve lift
- Intake valve lift - full load
- L
- Torque limiter 4
- Torque limiter for diagnostic
- Lambda enrichment for components protection
- RPM Limiter
- RPM Limiter 2
- RPM limit for ECT sensor
- Boost pressure linearization
- Lambda driver wish
- Knock detection factor
- Speed limiter
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Optimal engine moment
- Pressure ratio depending on IAT
- Maximum pressure ratio limit depending on temperature
- Maximum pressure ratio limit depending on ECT
- Requested engine filling
- Driver torque request
- Wastegate duty-cycle
固件标识 (2)
| 硬件号 | 软件号 (chip) | 版本 | 升级软件 | ECU |
|---|
| 00001243032701 | 00000ABF3B9101 |
1.98.016 | 0000139B3B9102 |
BOSCH MEVD17.2.4 |
| 00001243032701 | 00000ABF3B9601 |
1.98.002 | 0000139B3B9601 |
BOSCH MEVD17.2.4 |
车辆技术说明
OBD located to the left of the driver's side, in the bulkhead close to the bonnet release lever.
ECU 说明
MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
