BMW 3 SERIES F30/F31/F35 335iX 3.0L L6 24V HYBRID 250kW/335HP MEVD17.G

ECU BOSCH MEVD17.2.G · 340 CV (25 kW) · 3000 cc · Benzina sovralimentato

ECU 数据库BMW › BMW 3 SERIES F30/F31/F35 335iX 3.0L L6 24V HYBRID 250kW/335HP MEVD17.G

查找固件标识(硬件、软件和升级编号)、可用的调校选项,以及如何获取原始或改写文件。

✓ 通过文件调校 (flash) 4 固件版本

车辆数据

品牌BMW
型号3 SERIES F30/F31/F35
发动机335iX 3.0L L6 24V HYBRID 250kW/335HP MEVD17.G
原厂功率340 CV / 25 kW
排量3000 cc
燃料Benzina sovralimentato
车辆类型Auto

ECU

制造商BOSCH
型号MEVD17.2.G
存储 / EPROMMICRO ST TRICORE - 32768 Kbit - 400000

可用的调校选项:

  • Base timing
  • Base timing 2
  • Optimal spark timing/MBT
  • Boost pressure
  • Boost pressure 2
  • Desired engine load calculation
  • Maximum torque limitation at clutch
  • Characteristic line correction factor for pressure ratio for turbocharger overspeed protection
  • Gearbox maximum torque allowed
  • HFM/HLM threshold for diagnosis
  • High pressure fuel pump setpoint
  • Intake valve lift
  • Intake valve lift - full load
  • Torque limiter 2
  • L
  • Lambda enrichment for components protection
  • RPM Limiter
  • RPM Limiter 2
  • RPM limit for ECT sensor
  • Lambda driver wish
  • Knock detection factor
  • Speed limiter
  • Throttle air mass flow calculation
  • Manifold absolute pressure time delay
  • Characteristic manifold absolute pressure time constant of the LRS
  • Optimal engine moment
  • Pressure ratio depending on IAT
  • Maximum pressure ratio limit depending on temperature
  • Maximum pressure ratio limit depending on ECT
  • Requested engine filling
  • Driver torque request
  • Driver torque request Normal mode - AT
  • Driver torque request Sport mode - AT
  • Wastegate duty-cycle

固件标识 (4)

硬件号软件号 (chip)版本升级软件ECU
000020D5013101000021581D6401 1.98.00300001C591D6401 BOSCH MEVD17.2.G
000020D5013B01000021581DAA02 1.98.00300001C5D1DAA06 BOSCH MEVD17.2.G
000020D5013B01000021581D9101 1.98.01100001C591D9102 BOSCH MEVD17.2.G
000020D5013B01000021581DAA02 1.98.00400001C591DAA06 BOSCH MEVD17.2.G

ECU 说明

MICRO Infineon Tricore TC1797 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata