ECU 数据库 ›
AUDI › AUDI A5 (8F/8T) 2.0L 16V TFSI 132kW/177HP MED17.1
查找固件标识（硬件、软件和升级编号）、可用的调校选项，以及如何获取原始或改写文件。
✓ 通过文件调校 (flash)
✓ 附加模块可用 6 固件版本
车辆数据
| 品牌 | AUDI |
| 型号 | A5 (8F/8T) |
| 发动机 | 2.0L 16V TFSI 132kW/177HP MED17.1 |
| 原厂功率 | 179 CV / 132 kW |
| 排量 | 2000 cc |
| 燃料 | Benzina sovralimentato |
| 车辆类型 | Auto |
ECU
| 制造商 | BOSCH |
| 型号 | MED17.1 |
| 存储 / EPROM | MICRO ST TRICORE - 16384 Kbit - 200000 |
可用的调校选项:
- Maximum air charge for overboost protection with turbocharger fault
- Base timing
- Advance at idle speed
- Optimal spark timing/MBT
- Boost pressure limiter
- Height correction for boost pressure
- Desired engine load calculation
- Lambda correction for engine temperature after starting
- Maximum pressure ratio limit for diagnosis
- Exhaust gas temperature
- High pressure fuel pump setpoint
- High fuel pressure pump limit for ECT sensor
- Lambda enrichment for components protection
- Lambda correction for exhaust manifold temperature
- Torque limiter at high EGT
- RPM Limiter
- Lambda driver wish
- Knock detection factor
- Maximum boost pressure load
- Throttle air mass flow calculation
- Manifold absolute pressure time delay
- Characteristic manifold absolute pressure time constant of the LRS
- Maximum negative deviation for boost overcharge
- Optimal engine moment
- Power limit torque table
- Relative permissible torque from the pedal position in torque limitation
- Pressure ratio depending on IAT
- Maximum pressure ratio limit depending on temperature
- Driver torque request
- Exhaust gas temperature sensor
- Throttle angle management
固件标识 (6)
| 硬件号 | 软件号 (chip) | 版本 | 升级软件 | ECU |
|---|
| — | — |
1.94.028 | 8K2907115Q 0004 |
BOSCH MED17.1 |
| — | — |
1.94.021 | 8K2907115Q 0007 |
BOSCH MED17.1 |
| — | — |
1.94.032 | 8K2907115S 0004 |
BOSCH MED17.1 |
| — | — |
1.94.028 | 8K2907115S 0002 |
BOSCH MED17.1 |
| — | — |
1.94.029 | 8K2907115AF 0002 |
BOSCH MED17.1 |
| — | — |
1.94.017 | 8K2907115S 0005 |
BOSCH MED17.1 |
车辆技术说明
OBD located to the left of the driver's side, accessible without removing anything to the left of the pedalboard.
ECU 说明
MICRO Infineon Tricore TC1796 This setting file can be used with the New Genius, the protocol supports identification and writing only. IF the matching original file is already present in databank it can be used for the modification and the writing operation. To work on this ECU you can use NewTrasdata
